User Manual

Figure 3-15 Paern Conguraon
3. Select a paern.
4. Click Call to start the paern.
5. Oponal: Click Stop to stop the paern.
3.6.8 Set Linear Scan Limit
Linear Scan trigger a scan in the horizontal direcon in the predened range.
Before You Start
Make sure the connected IP camera supports the PTZ funcon and is properly connected.
Note
This funcon is supported only by some certain models.
Steps
1. Click on the quick sengs toolbar of the PTZ camera's live view.
2. Click
direconal buons to wheel the camera to a locaon, and click Le Limit or Right Limit to
link the locaon to the corresponding limit.
Note
The speed dome linear scans from the le limit to the right limit, and you must set the le limit
on the le side of the right limit. Also, the angle from the le limit to the right limit must be no
more greater than 180º.
3.6.9 One-Touch Park
Certain speed dome models can be congured to start a predened park acon (scan, preset,
patrol and etc.) automacally aer a period of inacvity (park me).
Before You Start
Before operang this funcon, make sure the connected camera supports linear scan and is in
HIKVISION protocol.
Network Video Recorder User Manual
36