Operation Manual
Table Of Contents
- Product Key Features
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Live View
- Chapter 4 PTZ Controls
- Chapter 5 Record Settings
- Chapter 6 Playback
- Chapter 7 Backup
- Chapter 8 Alarm Settings
- Chapter 9 Network Settings
- 9.1 Configuring General Settings
- 9.2 Configuring Advanced Settings
- 9.2.1 Configuring Extranet Access
- 9.2.2 Configuring PPPoE Settings
- 4.5.1 9.2.3 Configuring NTP Server
- 9.2.4 Configuring SNMP
- 9.2.5 Configuring NAT
- 9.2.6 Configuring Remote Alarm Host
- 9.2.7 Configuring Multicast
- 9.2.8 Configuring RTSP
- 9.2.9 Configuring Server and HTTP Ports
- 9.2.10 Configuring HTTPS Settings
- 9.2.11 Configuring Email
- 9.3 Checking Network Traffic
- 9.4 Network Detection
- Chapter 10 HDD Management
- Chapter 11 Camera Settings
- Chapter 12 Device Management and Maintenance
- Chapter 13 Others
- Chapter 14 Appendix
User Manual of DS-7200/7300/8100-SH Series DVR
63
4.2.1 Setting PTZ Presets, Patrols & Patterns
Before you start:
Make sure that the presets, patrols and patterns should be supported by PTZ protocols.
Customizing Presets
Purpose:
A preset is a predefined image position which contains information of pan, tilt, focus and other parameters.
You can customize the presets and the presets can be used with the event triggered action.
Steps:
1. Enter the PTZ Settings interface.
Menu> Camera >PTZ
Figure 4. 17 PTZ Settings-Customize Preset
2. Select the camera for PTZ setting from the drop-down list.
3. Use the directional and zoom / focus / iris buttons on the PTZ control panel to steer the camera to the
desired view.
4. Input the preset No. (1~255) in the Preset text field, and then click the Set button under the Preset item
to save the preset.
5. Repeat the steps 3-4 to save more presets.
6. You can click the Clear button under the Preset item to clear the selected preset or click the Clear All
button to clear all the presets.