Operation Manual
Table Of Contents
- Product Key Features
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Live View
- Chapter 4 PTZ Controls
- Chapter 5 Record Settings
- Chapter 6 Playback
- Chapter 7 Backup
- Chapter 8 Alarm Settings
- Chapter 9 Network Settings
- 9.1 Configuring General Settings
- 9.2 Configuring Advanced Settings
- 9.2.1 Configuring Extranet Access
- 9.2.2 Configuring PPPoE Settings
- 4.5.1 9.2.3 Configuring NTP Server
- 9.2.4 Configuring SNMP
- 9.2.5 Configuring NAT
- 9.2.6 Configuring Remote Alarm Host
- 9.2.7 Configuring Multicast
- 9.2.8 Configuring RTSP
- 9.2.9 Configuring Server and HTTP Ports
- 9.2.10 Configuring HTTPS Settings
- 9.2.11 Configuring Email
- 9.3 Checking Network Traffic
- 9.4 Network Detection
- Chapter 10 HDD Management
- Chapter 11 Camera Settings
- Chapter 12 Device Management and Maintenance
- Chapter 13 Others
- Chapter 14 Appendix
User Manual of DS-7200/7300/8100-SH Series DVR
182
10.7 Detecting Bad Sector
Purpose:
The bad sectors of a HDD may cause the system to slow down when reading or writing data. You can detect the
bad sectors of the HDD and thus to take immediate measures to repair it.
Steps:
1. Enter the Bad Sector Detection interface.
Menu> Maintenance >HDD Detect>Bad Sector Detection
Figure 10. 20 Bad Sector Detection
2. Select a HDD and click Detect to start detecting.
Figure 10. 21 Bad Sector Detecting
3. You can click Pause to pause the detection and click Resume to resume the detection.
4. If there is any error information about the HDD, you can click Error info to view the information.