User Manual

Table Of Contents
Digital Video Recorder User Manual
195
Chapter 12 Network Settings
12.1 Configuring General Settings
Purpose
Network settings must be properly configured before you operate DVR over network.
Step 1 Enter the Network Settings interface.
Menu > Configuration > Network
Figure 12-1 Network Settings Interface (1)
2 self-adaptive 10M/100M/1000M network interfaces for DS-8100HQHI-F/N and
DS-7300/8100/9000HUHI-F/N series. For DS-8100HQHI-F/N series, three working modes are
configurable: multi-address, load balance, network fault tolerance. For
DS-7300/8100/9000HUHI-F/N series, only multi-address and network fault tolerance are
configurable. 1 self-adaptive 10M/100M/1000M network interface or 1 self-adaptive
10M/100Mbps network interface provided for other models.
Step 2 Select the General tab.
Step 3 In the General Settings interface, you can configure the following parameters: Working
Mode (applicable for DS-8100HQHI-F/N and DS-7300/8100/9000HUHI-F/N series), NIC Type,
IPv4 Address, IPv4 Gateway, MTU, DNS Server and Main NIC.
Working Mode
There are two 10M/100M/1000M NIC cards provided by the DS-8100HQHI-F/N and
DS-7300/8100/9000HUHI-F/N series devices, and it allows the device to work in the
Multi-address, Load Balance and Net-fault Tolerance modes for DS-8100HQHI-F/N and
Multi-address and Net-fault Tolerance for DS-7300/8100/9000HUHI-F/N.