User Manual

DS-720xHTI-Kx DVR User Manual
UM DS-720xHTI-Kx 012918NA 100
Figure 8-5 Motion Detection
2. Select the connected PIR camera.
3. Check Enable Motion Detection.
4. Check False Alarm Filter to enable PIR motion detection. The message box pops up as below.
Figure 8-6 Note
5. Click OK to enable PIR motion detection. Then, only when the motion detection events and PIR events
are both triggered, the motion detection alarm will be triggered.
6. Set detection area and sensitivity. Refer to 8.1 Setting Motion Detection .
7. Click Set to set motion detection alarm response actions. See 8.1 Setting Motion Detection .
8. Click Apply to save the settings.
This function is applicable only to Hikvision PIR analog cameras.
The PIR alarm does not support detection area configuration. It is full screen by default.
The PIR alarm does not support sensitivity configuration.
If you disable the false alarm filter, only when the motion detection events are triggered will the
motion detection alarm be triggered. The PIR alarm will not be considered.