User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Panels and Connections
- Chapter 3 Getting Started
- Chapter 4 Decoder Configuration and Operation by Web Browser
- 4.1 Decoder Configuration
- 4.1.1 Checking Device Information
- 4.1.2 Configuring Time Settings
- 4.1.3 Configuring RS-485/RS-232 Serial Port
- 4.1.4 Configuring Basic Network Settings
- 4.1.5 Configuring DDNS Settings
- 4.1.6 Configuring Wi-Fi Settings
- 4.1.7 Configuring Stream Settings
- 4.1.8 Configuring Transparent Channel
- 4.1.9 Configuring Synchronous Output Settings
- 4.1.10 Configuring Personalized Settings
- 4.1.11 Managing User Account
- 4.1.12 Importing/Exporting Configuration Files
- 4.1.13 Maintenance
- 4.2 Setting Video Wall Layout
- 4.3 Configuring Decoding Output
- 4.4 Decoding Operation
- 4.1 Decoder Configuration
- Chapter 5 Decoder Configuration and Operation by Client Software
- Chapter 6 Display via Wi-Fi Connection
- Chapter 7 Appendix
HD Video and Audio Decoder User Manual
DS-6900UDI Decoder User Manual
82
Check the checkbox of Enable to enable Wi-Fi. Step 2
Input an effective SSID. Step 3
Click WLAN Settings tab to enter the WLAN Settings interface. Step 4
WLAN Settings Figure 5-61
Select the NIC Type to Auto-Switch and check the checkbox of Enable DHCP. Click Save to Step 5
save the settings and the device will reboot to enter the Wi-Fi mode.
If you want to enable Wi-Fi, you must select NIC Type to Auto-Switch. In this mode, if wired
network cable is connected, wired network will be connected by priority. If wired network cable is
not connected, the configured Wi-Fi will be connected.
After the device reboots, enter the remote Wi-Fi settings interface. Click to Step 6
select a Wi-Fi from the list and click Save to enable the selected Wi-Fi.
Select Wi-Fi Figure 5-62