User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Panels and Connections
- Chapter 3 Getting Started
- Chapter 4 Decoder Configuration and Operation by Web Browser
- 4.1 Decoder Configuration
- 4.1.1 Checking Device Information
- 4.1.2 Configuring Time Settings
- 4.1.3 Configuring RS-485/RS-232 Serial Port
- 4.1.4 Configuring Basic Network Settings
- 4.1.5 Configuring DDNS Settings
- 4.1.6 Configuring Wi-Fi Settings
- 4.1.7 Configuring Stream Settings
- 4.1.8 Configuring Transparent Channel
- 4.1.9 Configuring Synchronous Output Settings
- 4.1.10 Configuring Personalized Settings
- 4.1.11 Managing User Account
- 4.1.12 Importing/Exporting Configuration Files
- 4.1.13 Maintenance
- 4.2 Setting Video Wall Layout
- 4.3 Configuring Decoding Output
- 4.4 Decoding Operation
- 4.1 Decoder Configuration
- Chapter 5 Decoder Configuration and Operation by Client Software
- Chapter 6 Display via Wi-Fi Connection
- Chapter 7 Appendix
HD Video and Audio Decoder User Manual
DS-6900UDI Decoder User Manual
72
Check the checkbox of Enable Ship Detection to enable the function. Step 3
Check the checkbox of Display Detection Frame on Video to display the frame and alarm Step 4
line on stream.
Input the device height in the textbox as the height of device above the water level. Step 5
Draw the ship detection area and the alarm lines. Step 6
1. Click Draw Area button. Click the mouse on the live view image to draw a ship detection
area and right-click to finish drawing. The alarm will be uploaded when ship is detected in
this area.
2. Click Draw Alarm Line button. Click the mouse on the live view image to draw an alarm
line and right-click to finish drawing. The device alarms and counts the ship number when
ships are detected in the area and the ship information will be displayed on the right.
Make sure the alarm line is longer than the width of ship detection area.
3. Click Recount to start counting the ships detected in the area afterwards.
Check the checkbox to select the linkage method taken for the alarm input. Step 7
Click Save to save the settings. Step 8
Configuring VCA
Configure the live view parameters to enable rules. Step 1
1. Click Configuration > Local Configuration to enter the Local Configuration interface.
Local Configuration Figure 5-44