User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Panels and Connections
- Chapter 3 Getting Started
- Chapter 4 Decoder Configuration and Operation by Web Browser
- 4.1 Decoder Configuration
- 4.1.1 Checking Device Information
- 4.1.2 Configuring Time Settings
- 4.1.3 Configuring RS-485/RS-232 Serial Port
- 4.1.4 Configuring Basic Network Settings
- 4.1.5 Configuring DDNS Settings
- 4.1.6 Configuring Wi-Fi Settings
- 4.1.7 Configuring Stream Settings
- 4.1.8 Configuring Transparent Channel
- 4.1.9 Configuring Synchronous Output Settings
- 4.1.10 Configuring Personalized Settings
- 4.1.11 Managing User Account
- 4.1.12 Importing/Exporting Configuration Files
- 4.1.13 Maintenance
- 4.2 Setting Video Wall Layout
- 4.3 Configuring Decoding Output
- 4.4 Decoding Operation
- 4.1 Decoder Configuration
- Chapter 5 Decoder Configuration and Operation by Client Software
- Chapter 6 Display via Wi-Fi Connection
- Chapter 7 Appendix
HD Video and Audio Decoder User Manual
DS-6900UDI Decoder User Manual
70
Live View Figure 5-41
Configuring Dynamic Fire Source Detection
Configure the VCA resource type. Step 1
1. Log in to the camera via the Web browser.
2. Click Configuration > Advanced Configuration > System > VCA Resource Type to enter
the VCA Resource Type configuration interface.
3. Select Dynamic Fire Source Detection as the VCA Resource Type.
4. Click Save to save the settings and the device will reboot to take the settings into effect.
For the VCA resource type, only one type can be configured. For example, if you select
Temperature Measurement and Behavior Analysis as the VCA resource type, you cannot set
Dynamic Fire Source Detection.
Configure dynamic fire source detection parameters. Step 2
1. Click Configuration > Advanced Configuration > Smart Event > Dynamic Fire Source
Detection to enter the Dynamic Fire Source Detection configuration interface.
Dynamic Fire Source Detection Figure 5-42