User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Panels and Connections
- Chapter 3 Getting Started
- Chapter 4 Decoder Configuration and Operation by Web Browser
- 4.1 Decoder Configuration
- 4.1.1 Checking Device Information
- 4.1.2 Configuring Time Settings
- 4.1.3 Configuring RS-485/RS-232 Serial Port
- 4.1.4 Configuring Basic Network Settings
- 4.1.5 Configuring DDNS Settings
- 4.1.6 Configuring Wi-Fi Settings
- 4.1.7 Configuring Stream Settings
- 4.1.8 Configuring Transparent Channel
- 4.1.9 Configuring Synchronous Output Settings
- 4.1.10 Configuring Personalized Settings
- 4.1.11 Managing User Account
- 4.1.12 Importing/Exporting Configuration Files
- 4.1.13 Maintenance
- 4.2 Setting Video Wall Layout
- 4.3 Configuring Decoding Output
- 4.4 Decoding Operation
- 4.1 Decoder Configuration
- Chapter 5 Decoder Configuration and Operation by Client Software
- Chapter 6 Display via Wi-Fi Connection
- Chapter 7 Appendix
HD Video and Audio Decoder User Manual
DS-6900UDI Decoder User Manual
69
5. Set Temperature Difference Alarm. Click Temperature Difference Alarm to enter the
temperature difference alarm interface, up to four temperature difference alarms can be
set.
Temperature Difference Alarm is only applicable to the targets set by frame.
6. Set Alarm Linkage. Click Alarm Linkage to enter the alarm linkage interface and set the
linkage methods.
7. Click Save to save the settings.
Configure the local parameters to display the temperature information on the live view Step 4
interface.
1. Click Configuration > Local Configuration to enter the Local Configuration interface.
Local Configuration Figure 5-40
2. In the Live View Parameters section, select the Enable radio button of Display
Temperature Info. on Stream to display the temperature information on the live view
interface.
3. Click Save to save the settings and then you can view the position of the configured point,
line and frame, the ID and temperature information on the live view interface.