User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Panels and Connections
- Chapter 3 Getting Started
- Chapter 4 Decoder Configuration and Operation by Web Browser
- 4.1 Decoder Configuration
- 4.1.1 Checking Device Information
- 4.1.2 Configuring Time Settings
- 4.1.3 Configuring RS-485/RS-232 Serial Port
- 4.1.4 Configuring Basic Network Settings
- 4.1.5 Configuring DDNS Settings
- 4.1.6 Configuring Wi-Fi Settings
- 4.1.7 Configuring Stream Settings
- 4.1.8 Configuring Transparent Channel
- 4.1.9 Configuring Synchronous Output Settings
- 4.1.10 Configuring Personalized Settings
- 4.1.11 Managing User Account
- 4.1.12 Importing/Exporting Configuration Files
- 4.1.13 Maintenance
- 4.2 Setting Video Wall Layout
- 4.3 Configuring Decoding Output
- 4.4 Decoding Operation
- 4.1 Decoder Configuration
- Chapter 5 Decoder Configuration and Operation by Client Software
- Chapter 6 Display via Wi-Fi Connection
- Chapter 7 Appendix
HD Video and Audio Decoder User Manual
DS-6900UDI Decoder User Manual
18
Click Save to save the settings. Step 4
Configure RS-485 Parameters
Click Configuration > System Settings > RS-485 to enter the following interface: Step 1
Configure RS-485 Settings Figure 4-9
Configure the RS-485 parameters, including the baud rate, data bit, stop bit and parity type. Step 2
Click Save to save the settings. Step 3
Configuring Basic Network Settings 4.1.4
Purpose
You can set the network parameters for the decoder in the parameter configuration interface.
Click Configuration > Network > TCP/IP to enter the general network settings interface. Step 1
Configure Basic Network Settings Figure 4-10