User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Panels and Connections
- Chapter 3 Getting Started
- Chapter 4 Decoder Configuration and Operation by Web Browser
- 4.1 Decoder Configuration
- 4.1.1 Checking Device Information
- 4.1.2 Configuring Time Settings
- 4.1.3 Configuring RS-485/RS-232 Serial Port
- 4.1.4 Configuring Basic Network Settings
- 4.1.5 Configuring DDNS Settings
- 4.1.6 Configuring Wi-Fi Settings
- 4.1.7 Configuring Stream Settings
- 4.1.8 Configuring Transparent Channel
- 4.1.9 Configuring Synchronous Output Settings
- 4.1.10 Configuring Personalized Settings
- 4.1.11 Managing User Account
- 4.1.12 Importing/Exporting Configuration Files
- 4.1.13 Maintenance
- 4.2 Setting Video Wall Layout
- 4.3 Configuring Decoding Output
- 4.4 Decoding Operation
- 4.1 Decoder Configuration
- Chapter 5 Decoder Configuration and Operation by Client Software
- Chapter 6 Display via Wi-Fi Connection
- Chapter 7 Appendix
HD Video and Audio Decoder User Manual
DS-6900UDI Decoder User Manual
16
Configure Time Settings Figure 4-5
Configure the time synchronization by NTP server or manually. Step 2
Configuring Time Synchronization by NTP Server
A Network Time Protocol (NTP) Server can be configured on your device to ensure the
accuracy of system date/time.
If the device is connected to a Dynamic Host Configuration Protocol (DHCP) network that
has time server properties configured, the camera will synchronize automatically with the
time server.
Enable the NTP function by selecting the radio button, and configure the following
settings:
NTP Server: IP address of NTP server.
NTP Port: Port of NTP server.
Configure Time by NTP Figure 4-6
If the device is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the device is set up in a more customized network, NTP software can be used to
establish a NTP server used for time synchronization.
Configuring Time Synchronization Manually