User Manual

DS-6700HQHI-SATA Series Encoder User Manual
69
Chapter 10 Log Search and Maintenance
10.1 Log Search
Purpose
The operation, alarm, exception and information of the device can be stored in log files, which can be viewed and
exported at any time.
Before you start
The Log function can be realized only when the Encoder is connected with HDD or network disk. And make sure
the HDD or network disk has been initialized for the first time to use . Please refer to Section Adding Network Disk
for details.
Steps:
1. Click Log on the menu bar to enter the Log interface.
2. Set the log search conditions to refine your search, including the Major Type, Minor Type, Start Time and End
Time.
3. Click the Search button to start searching log files.
4. The matched log files will be displayed on the list shown below.
Up to 2000 log files can be displayed each time.
Figure 10. 1 Log Search Interface