User Manual

DS-6700HQHI-SATA Series Encoder User Manual
52
Steps:
(1) Click the Linkage Method tab to enter the setting interface.
(2) Select the alarming linkage method(s) including Audible Warning, Notify Surveillance Center, Send
Email and Upload to FTP.
 Audible Warning
Trigger an audible beep when an alarm is detected.
 Notify Surveillance Center
Send an exception or alarm signal to remote alarm host when an event occurs. The alarm host refers to
the PC installed with Remote Client.
 Send Email
Send an email with alarm information to a user or users when an event occurs.
To send the Email when an event occurs, you need to go to the network setting interface to set the
related parameters. Refer to Section Configuring Email Settings.
 Upload to FTP
Capture the image when an alarm is triggered and upload the picture to a FTP server.
(3) Select the channel you want to trigger an external alarm output when a motion detection event occurs.
Figure 6. 14 Motion Detection-Trigger Alarm Output
To trigger an external alarm output when an event occurs, you need to go to the Alarm Output Settings
interface to set the related parameters.
1) Click Remote Configuration> Alarm Settings> Alarm Output to enter the Alarm Output
Settings interface.