User Manual

DS-6700HQHI-SATA Series Encoder User Manual

Figure 5. 21 Initial Disk

4) Set the property of the added network disk.

Select the HDD No., and select the property from the drop-down menu to R/W, Read-only or Redundancy.

Figure 5. 22 Set HDD Property

 Please refer to the User Manual of IP SAN/NAS for the creation of File Path in the network management.

 Up to 8 NAS disks and 1 IP SAN disk can be connected to the DS-6700HQHI-SATA.

5.3.7 Configuring SNMP Settings

Simple Network Management Protocol (SNMP) is an Internet-standard protocol for managing devices on IP

networks

You can use SNMP to get camera status, parameters and alarm related information.

Before you start:

Before setting the SNMP, please download the SNMP software and manage to receive the device information via

SNMP port. By setting the Trap Address, the device can send the alarm event and exception messages to the

surveillance center.

The SNMP version you select should be the same as that of the SNMP software.

Steps:

1. Click Remote Configuration > Network Settings >SNMP to enter the SNMP settings interface.

Check the checkbox to enable SNMP v2c, and configure the read SNMP community (default: public), write

SNMP community (default: private), tap address (default: empty) and trap port (default: 162).