User Manual

DS-6700HQHI-SATA Series Encoder User Manual
31
The valid value range of MTU is 500 to 1500.
3. If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP address
and other network settings from that server.
4. If the DNS server settings are required for some applications (e.g., sending email), you should properly
configure the Preferred DNS Server and Alternate DNS Sever here.
Figure 5. 9 DNS Server Settings
5. Click the Save button to save the above settings.
5.3.2 Configuring Port Settings
Purpose:
You can set the port No. of the encoder, e.g., HTTP port, RTSP port and HTTPS port.
Steps:
1. Click Remote Configuration > Network Settings > Port to enter the Port Settings interface:
Figure 5. 10 Port Settings
2. Set the HTTP port, RTSP port, HTTPS port, and Server Port 8000 of the camera.
HTTP Port: The default port number is 80.
RTSP Port: The default port number is 554.
HTTPS Port: The default port number is 443.
Server Port: The default port number is 8000.
3. Click Save to save the settings.
It will ask you to reboot the device to activate the settings.