User Manual

DS-6700HQHI-SATA Series Encoder User Manual
21
3. Record Settings .
4. Setting the image quality of live view on Section Local Configuration.
5. Setting the saving path for the recorded video files and captured pictures on Section Local Configuration.
6. Setting the OSD text on live video on Section Configuring OSD Settings.
4.2 Capturing the Picture
In live view mode, click the button on the toolbar to capture the live pictures.
When the picture is captured, the following pop-up message box will appear at the lower right corner.
Figure 4. 3 Picture Capture Succeeded
 The saving path for the captured pictures can be set at the Configuration > Local Configuration page.
 The image is saved as a JPEG file on your computer.
4.3 Operating PTZ Control
Before you start:
1. Make sure the encoder is connected with the camera/dome which supports PTZ function. Connect the R+ and
R- terminals of the pan/tilt unit or speed dome to RS-485 D+ and RS-485 D- terminals of the
DS-6700HQHI-SATA respectively.
2. The baud rate, PTZ control and address configured in the RS-485 Settings interface (Remote
Configuration > Serial Port Settings > 485 Serial Port), as shown in Figure 6.3, must be the same with the
parameters of the connected pan/tilt unit or speed dome.
Figure 4. 4 RS-485 Settings