User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Structure
- Chapter 3 Network Parameters Configuration
- Chapter 4 Access to DS-6700 by Client Software
- Chapter 5 Access to DS-6700 by WEB Browser
- Chapter 6 Live View
- Chapter 7 Device Configuration
- 7.1 Local Configuration
- 7.2 Configuring Time Settings
- 7.3 Network Settings
- 7.3.1 Configuring TCP/IP Settings
- 7.3.2 Configuring Port Settings
- 7.3.3 Configuring DDNS Settings
- 7.3.4 Configuring PPPoE Settings
- 7.3.5 Configuring Email Settings
- 7.3.6 Adding Network Disk
- 7.3.7 Configuring SNMP Settings
- 7.3.8 Configuring QoS Settings
- 7.3.9 Configuring FTP Settings
- 7.3.10 Configuring SOCKS Settings
- 7.3.11 Configuring UPnPTM Settings
- 7.3.12 Configuring HTTPS Settings
- 7.3.13 Configuring Bonjour Settings
- 7.3.14 Configuring IP Address Filter
- 7.3.15 Configuring Multicast Address
- Chapter 8 Camera Settings
- Chapter 9 Record/Capture Settings
- Chapter 10 Playback
- Chapter 11 Managing User Accounts
- Chapter 12 Log Search and Maintenance
- Chapter 13 FAQ
User Manual of DS-6700 Series Audio/Video Encoder
67
Figure 8.26 RS-485 Port Settings
2. Set the RS-485 parameters.
By default, the Baud Rate is set as 9600, the Data Bit as 8, the Stop Bit as 1 and the Parity and Flow Control
as None.
Note: The Baud Rate, Address and PTZ Protocol parameters should be exactly the same as the parameters of
the connected PTZ camera.
3. Click Save to save the settings.