User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Structure
- Chapter 3 Network Parameters Configuration
- Chapter 4 Access to DS-6700 by Client Software
- Chapter 5 Access to DS-6700 by WEB Browser
- Chapter 6 Live View
- Chapter 7 Device Configuration
- 7.1 Local Configuration
- 7.2 Configuring Time Settings
- 7.3 Network Settings
- 7.3.1 Configuring TCP/IP Settings
- 7.3.2 Configuring Port Settings
- 7.3.3 Configuring DDNS Settings
- 7.3.4 Configuring PPPoE Settings
- 7.3.5 Configuring Email Settings
- 7.3.6 Adding Network Disk
- 7.3.7 Configuring SNMP Settings
- 7.3.8 Configuring QoS Settings
- 7.3.9 Configuring FTP Settings
- 7.3.10 Configuring SOCKS Settings
- 7.3.11 Configuring UPnPTM Settings
- 7.3.12 Configuring HTTPS Settings
- 7.3.13 Configuring Bonjour Settings
- 7.3.14 Configuring IP Address Filter
- 7.3.15 Configuring Multicast Address
- Chapter 8 Camera Settings
- Chapter 9 Record/Capture Settings
- Chapter 10 Playback
- Chapter 11 Managing User Accounts
- Chapter 12 Log Search and Maintenance
- Chapter 13 FAQ
User Manual of DS-6700 Series Audio/Video Encoder
66
Note: Up to 4 privacy mask areas can be configured.
6. When finishing the area setting, click the button to finish drawing.
You can click the button to clear all of the areas you set without saving it.
7. Click Save to save the settings.
8.6 Configuring RS-232/485 Settings
8.6.1 RS-232 Settings
Note: The DS-6701HWI-HFI models provide no RS-232 serial port.
Purpose:
The RS-232 serial port can be used for the configuration by the serial port management tools.
Steps:
1. Click Remote Configuration> Serial Port Settings> 232 Serial Port to enter RS-232 port setting interface:
Figure 8.25 RS-232 Port Settings
Note: If you want to connect the encoder by the RS-232 port, the parameters of the RS-232 should be exactly the
same with the parameters you configured here.
2. Click Save to save the settings.
8.6.2 RS-485 Settings
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of the PTZ parameters should be
done before you control the PTZ unit.
Steps:
1. Click Remote Configuration> Serial Port Settings> 485 Serial Port to enter RS-485 port setting interface: