User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Structure
- Chapter 3 Network Parameters Configuration
- Chapter 4 Access to DS-6700 by Client Software
- Chapter 5 Access to DS-6700 by WEB Browser
- Chapter 6 Live View
- Chapter 7 Device Configuration
- 7.1 Local Configuration
- 7.2 Configuring Time Settings
- 7.3 Network Settings
- 7.3.1 Configuring TCP/IP Settings
- 7.3.2 Configuring Port Settings
- 7.3.3 Configuring DDNS Settings
- 7.3.4 Configuring PPPoE Settings
- 7.3.5 Configuring Email Settings
- 7.3.6 Adding Network Disk
- 7.3.7 Configuring SNMP Settings
- 7.3.8 Configuring QoS Settings
- 7.3.9 Configuring FTP Settings
- 7.3.10 Configuring SOCKS Settings
- 7.3.11 Configuring UPnPTM Settings
- 7.3.12 Configuring HTTPS Settings
- 7.3.13 Configuring Bonjour Settings
- 7.3.14 Configuring IP Address Filter
- 7.3.15 Configuring Multicast Address
- Chapter 8 Camera Settings
- Chapter 9 Record/Capture Settings
- Chapter 10 Playback
- Chapter 11 Managing User Accounts
- Chapter 12 Log Search and Maintenance
- Chapter 13 FAQ
User Manual of DS-6700 Series Audio/Video Encoder
31
The preset can also be used to link to the alarm input when there is alarm event occurring.
Figure 6.7 PTZ Linking
Please refer to Chapter 8.4 Configuring and Handling Alarms for the PTZ Linking settings (Remote
Configuration>Alarm Settings>Alarm Input>Linkage Method).
6.4 Configuring Video Parameters
Purpose:
You can configure the video parameters, including the brightness, contrast, saturation and hue.
Steps:
1. In the live view interface, click the button on the bottom right corner to spread the Video
Parameters Setting interface:
Figure 6.8 Video Parameters Settings
2. Select the mode according to different light conditions. Four modes are selectable:
Standard: in general lighting conditions (default).
Indoor: the image is relatively smoother.
Outdoor: the image is relatively clearer and sharper. The degree of contrast and saturation is high.
Dim Light: the image is smoother than the other three modes.
3. Move the slider to set the brightness, contrast, saturation and hue to 0~255. The default value is 128 for the
brightness, contrast and hue is 128 and 136 for the saturation.