User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Structure
- Chapter 3 Network Parameters Configuration
- Chapter 4 Access to DS-6700 by Client Software
- Chapter 5 Access to DS-6700 by WEB Browser
- Chapter 6 Live View
- Chapter 7 Device Configuration
- 7.1 Local Configuration
- 7.2 Configuring Time Settings
- 7.3 Network Settings
- 7.3.1 Configuring TCP/IP Settings
- 7.3.2 Configuring Port Settings
- 7.3.3 Configuring DDNS Settings
- 7.3.4 Configuring PPPoE Settings
- 7.3.5 Configuring Email Settings
- 7.3.6 Adding Network Disk
- 7.3.7 Configuring SNMP Settings
- 7.3.8 Configuring QoS Settings
- 7.3.9 Configuring FTP Settings
- 7.3.10 Configuring SOCKS Settings
- 7.3.11 Configuring UPnPTM Settings
- 7.3.12 Configuring HTTPS Settings
- 7.3.13 Configuring Bonjour Settings
- 7.3.14 Configuring IP Address Filter
- 7.3.15 Configuring Multicast Address
- Chapter 8 Camera Settings
- Chapter 9 Record/Capture Settings
- Chapter 10 Playback
- Chapter 11 Managing User Accounts
- Chapter 12 Log Search and Maintenance
- Chapter 13 FAQ
User Manual of DS-6700 Series Audio/Video Encoder
15
2.3 Alarm Connections
2.3.1 Alarm Input Connections
DS-6700 supports the open/close relay input as the alarm input mode. For the alarm input signal not in open/close
relay signal mode, please follow the connections shown as below:
Alarm input connections for Emerson Alarm:
Encoder
Note: The relay input port of the Encoder should be set to NC mode.
Figure 2.9 Alarm Input Connections for Emerson Alarm
Alarm input connections for Normal Alarm:
Encoder
Figure 2.10 Alarm Input Connections for Normal Alarm
2.3.2 Alarm Output Connections
DS-6700 supports the open/close relay input as the alarm output mode. The alarm input can be selected to NO or
NC. Different alarm output connection methods are applied to the AC or DC load. Please refer to the following
diagram:
Alarm output connections diagram:
Figure 2.11 Alarm Output Connections