User Manual
Table Of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Panels and Connections
- CHAPTER 3 Initial Network Parameters Configuration
- CHAPTER 4 Decoder Configuration and Operation by Web Browser
- 4.1 Decoding Operation
- 4.1.1 Configuring Decoded Video Display
- 4.1.2 Configuring Dynamic Decoding
- 4.1.3 Configuring Cycle Decoding
- 4.1.4 Configuring Video Wall Display
- 4.1.5 Enabling/Disabling the Decoding Channel
- 4.1.6 Configuring Picture Overlay
- 4.1.7 Checking the Connection Status
- 4.1.8 Checking the Decoding Channel Status
- 4.1.9 Checking the Display Channel Status
- 4.1.10 Configuring Transparent Channel
- 4.2 Decoder Configuration
- 4.2.1 Checking Device Information
- 4.2.2 Configuring Time Settings
- 4.2.3 Configuring Basic Network Settings
- 4.2.4 Configuring DDNS Settings
- 4.2.5 Configuring RS-485/RS-232 Serial Port
- 4.2.6 Configuring Alarm Input / Output Settings
- 4.2.7 Configuring Arming Time
- 4.2.8 Managing User Account
- 4.2.9 Importing/Exporting Parameters
- 4.3 Configuring Remote Playback
- 4.4 Switching Working Mode
- 4.5 Rebooting, Upgrading and Restoring the Default Settings for the Decoder
- 4.1 Decoding Operation
- CHAPTER 5 Decoder Configuration and Operation by Client Software
- CHAPTER 6 Appendix
User Manual of DS-6400HDI-T Decoder
38
During the playback, use the buttons to start playing, stop playing, slow
forward, fast forward, and turn on audio respectively.
Figure 4.40 Playback Control
Notes:
The speed of slow forward can be set to 1/2X, 1/4X and 1/8X; and the speed of fast forward can be set to 2X,
4X and 8X.
The speed of fast forward and slow forward is not supported in the VCA playback mode.
During decoding the playback on the screen, if you change the resolution of the video output, the decoding
stops.
4.3.2 VCA Playback
The decoder is able to play back the video files from the Smart DVR/NVR, and the event video file is played at
normal speed while the video file with no event is played at 8X speed.
Steps:
1) Click Device Management >Switch Mode to enter the switch mode interface.
2) Select the working mode to VCA Mode.
3) Restart the device to activate the new settings.
4) Enter the Remote Playback interface. Follow the same the steps described in Section 4.3.1 Normal
Playback.
Note: The VCA video files can be played by time only.