User Manual
Table Of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Panels and Connections
- CHAPTER 3 Initial Network Parameters Configuration
- CHAPTER 4 Decoder Configuration and Operation by Web Browser
- 4.1 Decoding Operation
- 4.1.1 Configuring Decoded Video Display
- 4.1.2 Configuring Dynamic Decoding
- 4.1.3 Configuring Cycle Decoding
- 4.1.4 Configuring Video Wall Display
- 4.1.5 Enabling/Disabling the Decoding Channel
- 4.1.6 Configuring Picture Overlay
- 4.1.7 Checking the Connection Status
- 4.1.8 Checking the Decoding Channel Status
- 4.1.9 Checking the Display Channel Status
- 4.1.10 Configuring Transparent Channel
- 4.2 Decoder Configuration
- 4.2.1 Checking Device Information
- 4.2.2 Configuring Time Settings
- 4.2.3 Configuring Basic Network Settings
- 4.2.4 Configuring DDNS Settings
- 4.2.5 Configuring RS-485/RS-232 Serial Port
- 4.2.6 Configuring Alarm Input / Output Settings
- 4.2.7 Configuring Arming Time
- 4.2.8 Managing User Account
- 4.2.9 Importing/Exporting Parameters
- 4.3 Configuring Remote Playback
- 4.4 Switching Working Mode
- 4.5 Rebooting, Upgrading and Restoring the Default Settings for the Decoder
- 4.1 Decoding Operation
- CHAPTER 5 Decoder Configuration and Operation by Client Software
- CHAPTER 6 Appendix
User Manual of DS-6400HDI-T Decoder
24
2. Select a decode channel in the drop-down list in the Decode Channel field.
3. Set the decoding channel to On or Off.
4. Click Save to save the settings.
4.1.6 Configuring Picture Overlay
Purpose:
The Picture Overlay function can overlay a picture on the screen for the selected decode channel, and the position
of the picture overlaid on the screen can also be set here.
Steps:
1. Click Decode Operation > Decode Control > Picture Overlay to enter the following interface:
Figure 4.15 Configure Picture Overlay
2. Select the decode channel in the drop-down list in the Decoding Channel No. field.
3. Click Browse to choose a picture from the local directory, and then upload it by clicking the Upload
button.
4. Set the X coordinate and the Y coordinate of the picture displayed on the screen to move the picture up
and down and left and right.
Note: The picture must be in 24-bit BMP format and its width and height must be 32X pixel, with up to 128×128
resolution and 24 bits depth.
5. You can check the checkbox of Flash to set the display style of the picture.
6. Set the picture to show or hide.
7. Click Save to save the settings.
4.1.7 Checking the Connection Status
Purpose:
The connection status shows the status of the decoding status and the network connection status of the decoding
channel.
Click Decode Operation > Decoding Status > Connection Status to view the connection status of the current
decoding channel in IP mode, URL mode or DDNS mode.