Quick Start Guide

Network Mobile Camera·Quick Start Guide
15
15
3. Prepare the screws: Thread the provided bolt through the spring
leaves and the flat gaskets in order.
Bolt
Spring Leaf
Flat Gasket
+ +
Figure 2-2 Preparing the Screws
4. Disassemble the camera: Loosen and take off the four screws on
the camera cover, and separate the cover from the mounting base.
As shown in the Figure 2-3.
Camera Cover
Mounting Base
Figure 2-3 Disassemble the Camera
5. Align the mounting holes on the mounting base with the holes on
the mounting surface, and insert the prepared screws (see step 2)
into the holes.