User Manual

Table Of Contents
DS-2TD8167-190ZE2F/W Thermal & Optical Bi-Spectrum PTZ Network Camera User Manual
UM DS-2TD8167-190ZE2F/W 040521NA 83
13.10.3 Set DST
If the region where the device is located uses Daylight Saving Time (DST), you can set this function.
Steps
1. Go to Configuration System System Settings DST.
2. Check Enable DST.
3. Select Start Time, End Time and DST Bias.
4. Click Save.
13.11 Set RS-232
RS-232 can be used to debug the device or access a peripheral device. RS-232 can realize communication
between the device and computer or terminal when the communication distance is short.
Before You Start
Connect the device to a computer or terminal with an RS-232 cable.
Steps
1. Go to Configuration System System Settings RS-232.
2. Set RS-232 parameters to match the device with a computer or terminal.
3. Click Save.
13.12 Set RS-485
RS-485 is used to connect the device to an external device. You can use RS-485 to transmit the data
between the device and the computer or terminal when the communication distance is long.
Before You Start
Connect the device and computer or termial with an RS-485 cable.
Steps
1. Go to Configuration System System Settings RS-485.
2. Set the RS-485 parameters.
Keep the parameters of the device and the computer or terminal the same.
3. Click Save.