User Manual

DS-2TD8167-190ZE2F/W Thermal & Optical Bi-Spectrum PTZ Network Camera User Manual
UM DS-2TD8167-190ZE2F/W 040521NA 43
2. Choose one of the following methods to enable the function.
1) Click .
2)
Call patrol path no. 8.
3)
Select
and
call preset no. 45.
8.4 Set Pattern Scan
The device can move as the recorded pattern.
Steps
1. Click to show the PTZ control panel, and click .
2. Select one pattern scan path that needs to be set.
3. Click to start recording pattern scan.
4. Click PTZ control buttons as needed.
Recording stops when the space for pattern scan is 0%.
5. Click to complete one pattern scan path settings.
6. Click to call pattern scan.
Stop pattern scan
Reset pattern scan path
Delete the selected pattern scan
If you need to delete all the pattern scans, go to Configuration → PTZ → Clear Config, check
Clear All Patterns, and click Save.
8.5 Set Linear Scan
The device can perform auto scan in setting area for fire source detection.
Steps
1. Go to Configuration → PTZ → Linear Scan.
2. Select the camera channel.
3. Zoom in and zoom out the camera to the appropriate zoom ratio, and click Save Ratio.
Click Enable Saved Ratio to set the camera to the saved zoom ratio.
4. Check Enter Area Settings.