Quick Start Guide

Quick Start Guide of Thermal & Optical Bi-spectrum Network Bullet Camera
vii
● Make sure that the power has been disconnected before you
wire, install, or disassemble the device.
● Input voltage should meet both the SELV (Safety Extra Low
Voltage) and the Limited Power Source with 12 VDC, 24 VAC ,
or PoE (802.3af) according to the IEC60950-1 standard.
Please refer to technical specifications for detailed
information.
● Use the power adapter provided by qualified manufacturer.
Refer to the product specification for detailed power
requirements. It is recommended to provide independent
power adapter for each device as adapter overload may
cause over-heating or a fire hazard.
Battery
● DO NOT place the battery near heating or fire source. Avoid
direct sunlight.
● Improper use or replacement of the battery may result in
explosion hazard. Replace with the same or equivalent type
only. Dispose of used batteries according to the instructions
provided by the battery manufacturer.
● For long-term storage of the battery, make sure it is fully
charged every half year to ensure the battery quality.
Otherwise, damage may occur.
System Security
● You acknowledge that the nature of Internet provides for
inherent security risks, and our company shall not take any
responsibilities for abnormal operation, privacy leakage or
other damages resulting from cyber attack, hacker attack,