Quick Start Guide

Quick Start Guide of Thermal & Optical Bi-spectrum Network Bullet Camera
19
2) Loosen the tile adjusting screw to adjust the tilting position
[-45° to 45°]. Tighten the screw.
Tilting Position [-45° to 45°]
Tilt Adjustment
Please loosen the screws slightly until you can adjust the camera.
DO NOT remove the screws from the bracket.
2.3.2 Install Type II and Type IV Camera
Type II and Type IV cameras are installed in the same way. Here is an
example of installation for type II camera.
Steps:
1. Select the proper place, and attach the drill template onto the
wall/ceiling, as shown in Figure 2-9.