Quick Start Guide

Quick Start Guide of Thermal & Optical Bi-spectrum Network Bullet Camera
10
2 Installation
Before you start:
● Make sure the device in the package is in good condition and all
the assembly parts are included.
● The standard power supply is 12 VDC, 24 VAC, or PoE (802.3af).
Please make sure your power supply matches with your
camera.
● Make sure all the related devices are powered off during the
installation.
● Check the specification of the products for the installation
environment.
● Make sure that the wall is strong enough to withstand four
times the weight of the camera and the bracket.
For the camera that supports IR, pay attention to the following
precautions to prevent IR reflection:
● Dust or grease on the camera cover will cause IR reflection.
Please DO NOT remove the camera cover film until the
installation is finished. If there is dust or grease on the camera
cover, clean the camera cover with clean soft cloth and
isopropyl alcohol.
● Make sure that there is no reflective surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing reflection.
● DO NOT drag the camera with its waterproof cables, or the
waterproof performance is affected.