User Manual

Thermal Network Bullet Camera User Manual
87
Figure 9-12 Scene Change Detection
2. Check the checkbox of Enable to enable the function.
3. Click-and-drag the slider to set the detection sensitivity. The sensitivity value
ranges from 1 to 100, and the higher the value is, the more easily the change of
scene can trigger the alarm.
4. Click Arming Schedule to set the arming schedule. Refer to Task 2 Set the
Arming Schedule for Motion Detection in Section 9.1.1 for detailed steps.
5. Click Linkage Method to select the linkage methods for scene change, including
Notify Surveillance Center, Send Email, Upload to FTP/Memory Card/NAS,
Trigger Channel and Trigger Alarm Output.
6. Click Save to save the settings.
9.2.3 Configuring Dynamic Fire Source Detection
Before you start:
Go to Configuration > System > Maintenance > VCA Resource Configuration to
select Fire and Smoke Detection as VCA Resource Type.
Purpose:
When you enable this function and fire source is detected, the alarm actions will be