User Manual

Table Of Contents
DS-2TD2137-7P Thermal Network Camera User Manual
UM DS-2TD2137-7P 042021NA 16
position to be measured is.
Point: Refer to
Point Thermography
for detailed configuration.
Line: Refer to
Line Thermography
for detailed configuration.
Area: Refer to
Area Thermography
for detailed configuration.
3. Click and set the Alarm Rule.
Alarm Temperature and Pre-Alarm Temperature: Set the alarm temperature and pre-alarm
temperature. E.g., select Alarm Rule as Above (Average Temperature), set the Pre-Alarm
Temperature to 50° C, and set the Alarm Temperature to 5 C. The device pre-alarms when its
average temperature is higher than 50° C and alarms when its average temperature is higher than
55° C.
Tolerance Temperature: Set the tolerance temperature to prevent constant temperature change to
affect the alarm. E.g., set tolerance temperature as 3° C, set alarm temperature as 55° C, and set
pre-alarm temperature as 50° C. The device sends pre-alarm when its temperature reaches 50° C
and it alarms when its temperature reaches 55° C, and only when the device temperature is lower
than 52° C will the alarm be canceled.
4. Click Save.
5. Click Liveview, and you can view the temperature and rules information on live view.
Point Thermography
Configure the temperature measurement rule and click any point in live view to monitor the temperature.
Steps
1. Click in live view and a cross cursor shows on the interface.
2. Drag the cross cursor to the desired position.
3. Go to the Live View interface to view the temperature and rule of the point in the thermal channel.
Line Thermography
Configure the temperature measurement rule, and monitor the maximum temperature of the line.
Steps
1. Click and drag the mouse to draw a line in the live view interface.
2. Click and move the line to adjust the position.
3. Click and drag the ends of the line to adjust the length.
4. Go to the Live View interface to view the maximum temperature and rule of the line in the thermal
channel.