Quick Start Guide

DS-2TD2137-7P Thermal Network Bullet Camera Quick Start Guide
QSG DS-2TD2137-7P 041521NA 4
Laws and Regulations
• The lightning protection and grounding design of outdoor installation and wiring should be in
compliance with the lightning protection requirements of the buildings and local laws and regulations.
• Use of the product must be in strict compliance with the local electrical safety regulations.
Storage
• Store the device in dry, well-ventilated, corrosive-gas-free, no direct sunlight, and no heating source
environment. Neglect may cause fire hazard.
• To avoid heat accumulation, good ventilation is required for a proper operating environment.
• DO NOT touch the heat dissipation component, to avoid burns.
Transportation
• Keep the device in original or similar packaging while transporting it.
• Keep all packaging after unpacking for future use. In case any failure occurs, you need to return the
device to the factory in the original packaging. Transportation without the original packaging may
result in damage to the device, and the company shall not take any responsibilities.
• DO NOT drop the product or subject it to physical shock. Keep the device away from magnetic
interference.
Installation
• When the device is mounted on wall or ceiling, the device shall be firmly fixed.
• Avoid equipment installation on vibratory surfaces or places subject to shock (neglect may cause
equipment damage).
Power Supply
• Make sure that the power has been disconnected before you wire, install, or disassemble the device.
• The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra Low Voltage) and the
Limited Power Source. Refer to the appropriate documentation for detailed information. The standard
power supply is 12 VDC, 24 VAC, or PoE (802.3af), make sure your power supply matches your camera.
• Use a power adapter provided by a qualified manufacturer. Refer to the product specification for
detailed power requirements. It is recommended to provide an independent power adapter for each
device as adapter overload may cause overheating or a fire hazard.
Battery
• DO NOT place the battery near a heating or fire source. Avoid direct sunlight.
• Improper use or replacement of the battery may result in explosion hazard. Replace with the same or
equivalent type only. Dispose of used batteries according to the instructions provided by the battery
manufacturer.