Quick Start Guide
Table Of Contents
- Regulatory Information
- EU Conformity Statement
- Laws and Regulations
- Storage
- Transportation
- Installation
- Power Supply
- Battery
- System Security
- Maintenance
- Usage Environment
- Emergency
- 1. Appearance Description
- 2. Installation
- 3. Set the Network Camera over the LAN
- 4. Access via Web Browser
- 5. Appendix
DS-2TD2137-7P Thermal Network Bullet Camera Quick Start Guide
QSG DS-2TD2137-7P 041521NA 18
●
Type I Bracket
1)
Loosen the pan adjusting screw to adjust panning position [0° to 360°]. Tighten the screw.
2)
Loosen the tile adjusting screw to adjust the tilting position [0° to 100°]. Tighten the screw.
3)
Loosen the rotation adjusting screw to adjust the rotation position [0° to 360°]. Tighten the screw.
Figure 23, 3-Axis Adjustment
●
Type II Bracket
1) Loosen the screw to adjust the tilting position [0° to 90°]. Tighten the screw.
2) Loosen the screw to adjust the rotation position [0° to 360°]. Tighten the screw.
Figure 24, 2-Axis Adjustment
NOTE: Loosen the screws slightly until you can adjust the camera. DO NOT remove the
screws from the bracket.
2.4
Waterproof Measures
Purpose
If the camera is installed outdoors, use the waterproof accessory or tapes to waterproof the cables.
Otherwise the cables might get wet and a short circuit might occur.