Quick Start Guide
Table Of Contents
- Regulatory Information
- EU Conformity Statement
- Laws and Regulations
- Storage
- Transportation
- Installation
- Power Supply
- Battery
- System Security
- Maintenance
- Usage Environment
- Emergency
- 1. Appearance Description
- 2. Installation
- 3. Set the Network Camera over the LAN
- 4. Access via Web Browser
- 5. Appendix
DS-2TD2137-7P Thermal Network Bullet Camera Quick Start Guide
QSG DS-2TD2137-7P 041521NA 17
3.
(Optional) Affix the camera to the junction box.
1)
Attach the drill template (supplied) to the where you want to fix the junction box, and then drill four
holes in the ceiling/wall according to the drill template.
2)
(Optional) If you want to route cables through the installation surface, drill a cable hole according to
the drill template.
NOTE: Skip this step if you route the cable via the side opening
3)
Make sure
Top
is on the top and
bottom
is at the bottom. Fix the junction box to the installation
surface with the supplied screws.
4)
Fix the bullet camera to the junction box with the supplied screws, as shown below.
Figure 21, Install the Camera onto the Junction Box
4.
Fix the bullet camera to the installation surface with the supplied screws, as shown below.
Figure 22, Install the Bracket onto the Wall
5.
Adjust the camera to the optimal surveillance angle.