Quick Start Guide
Table Of Contents
- Regulatory Information
- EU Conformity Statement
- Laws and Regulations
- Storage
- Transportation
- Installation
- Power Supply
- Battery
- System Security
- Maintenance
- Usage Environment
- Emergency
- 1. Appearance Description
- 2. Installation
- 3. Set the Network Camera over the LAN
- 4. Access via Web Browser
- 5. Appendix
DS-2TD2137-7P Thermal Network Bullet Camera Quick Start Guide
QSG DS-2TD2137-7P 041521NA 14
NOTE: This table is for reference only, and the actual detection range may vary by
camera settings, mounting condition, monitor, etc.
2.3
Install Camera
2.3.1 Install Type I Camera
Before You Start
There are three Type I camera installation methods: wall mounting, ceiling mounting, and stand mounting.
Figure 14, Type I Camera Installation Methods
Steps
1.
Loosen the screws on the junction box cover.
2.
Draw the latches from the latch hole of the junction box, and remove the junction box cover.
Figure 15, Take Apart Junction Box
3.
Attach the drill template (supplied) to where you want to fix the camera, and then drill four screw holes
(recommended depth: 40 mm) in the ceiling/wall according to the drill template.
4.
Drill a cable hole according to the
A mark
of the drill template.
Lat ches
Lat ch Holes