User Manual

Thermal Network Bullet Camera User Manual
84
motion detection Refer to Task 2: Set the Arming Schedule for Motion Detection
in Section 9.1.1.
5. You can copy the settings to other alarm outputs.
6. Click Save to save the settings.
9.1.5 Handling Exception
The exception type can be HDD full, HDD error, network disconnected, IP address
conflicted and illegal login to the cameras.
Steps:
1. Enter the Exception Settings interface: Configuration > Event > Basic Event >
Exception.
2. Check the checkbox to set the actions taken for the Exception alarm. Refer to
Task 3: Set the Linkage Method for Motion Detection in 9.1.1for detailed steps.
Figure 9-10 Exception Settings
3. Click Save to save the settings.
9.2 Smart Events
You can configure the smart events by following the instructions in this section,
including audio exception detection, scene change detection, dynamic fire source
detection, and fire source detection shield, etc.
9.2.1 Configuring Audio Exception Detection
Purpose: