User Manual

Thermal Network Bullet Camera User Manual
71
Figure 8-4 Picture Overlay
2. Click Browse to select a picture.
3. Click Upload to upload it.
4. Check Enable Picture Overlay checkbox to enable the function.
5. Set X Coordinate and Y Coordinate values adjust the picture position on the
image. Adjust Picture Width and Picture Height to the desired size.
6. Click Save to save settings.
Note: The picture must be in RGB24 bmp format and the maximum picture size is
128*128.
8.5 Configuring DPC (Defective Pixel Correction)
Purpose:
DPC (Defective Pixel Correction) refers to the function that the camera can correct
the defective pixels on the LCD which are not performing as expected.
Note: This function is only available to certain camera models.
Steps:
1. Enter the DPC Settings interface: Configuration > Image > DPC