User Manual

Thermal Network Bullet Camera User Manual
104
Temperature.
E.g., select Alarm Rule as Temperature Difference is Higher than, and set the
Alarm Temperature to 10 °C, and the device alarms when the difference between
the minimum temperature and the maximum temperature of the region is higher
than 10 °C.
Task 2
For two alarm rules of frame, you can set the alarm for region temperature
difference.
a) Set the frame alarm rules.
b) Click to show the region temperature
difference alarm interface.
Figure 9-25 Region Temperature Difference Alarm
c) Select two rules to compare the saved regions.
d) Set the alarm rules and the temperature.
E.g., select Alarm Rule as Temperature Difference is Higher than, and enter 10 °C,
the device alarms when the difference between the minimum temperature and the
maximum temperature of the region is higher than 10 °C.
Note: Temperature Difference Alarm only applies to the targets set by frame.
3. Set Alarm Linkage: Click Alarm Linkage to enter the alarm linkage interface
and set the linkage methods. Refer to Step 3 in Section Configuring Motion
Detection. In the field of Other Linkage, you can check the checkbox to
enable the alarm output (The alarm output number varies depending on