User Manual

Thermometric Network Bullet Camera User Manual
76
5.7.1 Temperature Measurement Configuration
Steps:
1. Enter Configuration > Advanced Configuration > Temperature Measurement
Configuration.
Figure 5-47 Dynamic Fire Source Detection
2. Check the checkboxes of the interface to set the temperature measurement
configurations.
 Enable Temperature Measurement: Check the checkbox to enable
temperature measurement function.
 Display Temperature Info. on Stream: Check the checkbox to display
temperature information in live view.
 Add Original Data on Capture: Check the checkbox to add original data on
capture.
 Add Original Data on Stream: Check the checkbox to add original data on
stream.
 Data Refresh Interval: Select the data refresh interval from 1s to 5s.
 Unit: Display temperature with Degree Celsius (°C)/Degree Fahrenheit
(°F)/Degree Kelvin (K）.
 Temperature Range: Set the temperature range.
3. Clcik Save to save the settings .
5.7.2 Temperature Measurement and Alarm
Purpose:
This function is used for measuring the temperature of detected spot and the device
compares temperature of selected regions and alarms.
Steps:
1. Enter Configuration > Advanced Configuration > Temperature Measurement
and Alarm.