User Manual

Thermometric Network Bullet Camera User Manual
111
Figure 9-14 Import/Export Configuration File
9.7.4 Upgrading the System
Steps:
1. Enter the Maintenance interface:
Configuration > Basic Configuration> System > Maintenance
or Configuration > Advanced Configuration> System > Maintenance
2. Select firmware or firmware directory to locate the upgrade file.
Firmware: Locate the exact path of the upgrade file.
Firmware Directory: Only the directory the upgrade file belongs to is required.
3. Click Browse to select the local upgrade file and then click Upgrade to start
remote upgrade.
Figure 9-15 Remote Upgrade
Note: The upgrading process will take 1 to 10 minutes. Please don't disconnect
power to the device during the process. The device reboots automatically after
upgrade.
9.8 RS-485 Settings
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of
the PTZ parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS485