User Manual

Thermal Network Bullet Camera User Manual
7
exposed to the laser beam.
Do not place the camera in extremely hot, cold temperatures (the operating
temperature should be between -30° C to +60° C, or -40° C to +60° C if the
camera model has an "H" in its suffix), dusty or damp environment, and do
not expose it to high electromagnetic radiation.
To avoid heat accumulation, ensure there is good ventilation to the device.
Keep the camera away from water and any liquids.
While shipping, pack the camera in its original, or equivalent, packing
materials. Or packing the same texture.
Improper use or replacement of the battery may result in hazard of
explosion. Please use the manufacturer recommended battery type.
Notes:
For the camera supports IR, you are required to pay attention to the following
precautions to prevent IR reflection:
Dust or grease on the dome cover will cause IR reflection. Please do not
remove the dome cover film until the installation is finished. If there is dust
or grease on the dome cover, clean the dome cover with clean soft cloth
and isopropyl alcohol.
Make certain the installation location does not have reflective surfaces of
objects too close to the camera. The IR light from the camera may reflect
back into the lens causing reflection.
The foam ring around the lens must be seated flush against the inner