User Manual

Thermal Network Bullet Camera User Manual
142
20s, 25s, 30s or not limited.
Post-record: The time you set to stop recording after the scheduled
time or the event. For example, if an alarm triggered recording ends at
11:00, and the post-record time is set as 5 seconds, the camera records
until 11:00:05.
The Post-record time can be configured as 5s, 10s, 30s, 1 min, 2 min, 5
min or 10 min.
Stream Type: Select the stream type for recording.
Note: The record parameter configurations vary depending on the camera
model.
4. Select a Record Type. The record type can be Continuous, Motion Detection,
Alarm, Motion | Alarm, Motion & Alarm, and Event.
Continuous
If you select Continuous, the video will be recorded automatically
according to the time of the schedule.
Record Triggered by Motion Detection
If you select Motion Detection, the video will be recorded when the
motion is detected.
Besides configuring the recording schedule, you have to set the motion
detection area and check the checkbox of Trigger Channel in the
Linkage Method of Motion Detection Settings interface. For detailed
information, please refer to the Task 1: Set the Motion Detection Area in