User Manual

Thermal Network Bullet Camera User Manual
118
6. Set the shield area transparency to semitransparent, no-transparent, or
transparent.
7. Click Add to save the fire source detection shield, and it will be listed in the
Fire Source Detection Shield List area; you can select a region and click
Delete to delete it from the list; you can also define the color of the regions.
8. Check the checkbox of Enable Fire Source Detection Shield to enable this
function.
Note: You are allowed to draw up to 24 areas on the same image.
9.3 VCA Configuration
9.3.1 Configuring Overlay & Capture
Purpose:
You can enable to display the VCA information on stream or target information
on alarm picture and set the snapshot quality and resolution.
Steps:
1. Enter Configuration > VCA > Overlay & Capture.
2. Check the desired checkbox of display settings and select the snapshot
quality and resolution.