User Manual

Thermal Network Bullet Camera User Manual
116
Figure 9-13 Configuring Dynamic Fire Source Detection
3. Check the checkbox of Display Fire Source Frame on Stream to display a
red frame around the fire source on stream when fire occurs. (Optional)
4. You can drag the slider to adjust the sensitivity degree of dynamic fire
source detection from 1 to 10. The bigger the number is, the more
sensitive the detecting would be.
5. Check the checkbox to select the linkage method taken for the alarm input.
Please refer to Task 3: Set the Alarm Actions for Motion Detection in Section
9.1.1. In the field of Other Linkage, you can check the checkbox to enable
the alarm output (The alarm output number varies depending on device
ability).
6. Click Save to save the settings.
9.2.4 Configuring Fire Source Detection Shield
Purpose:
Fire Source Shield enables you to shield certain areas from being detected in