User Manual

Thermal Network Bullet Camera User Manual
114
Figure 9-12 Scene Change Detection
2. Check the checkbox of Enable to enable the function.
3. Click-and-drag the slider to set the detection sensitivity. The sensitivity
value ranges from 1 to 100, and the higher the value is, the more easily the
change of scene can trigger the alarm.
4. Click Arming Schedule to set the arming schedule. Refer to Task 2 Set the
Arming Schedule for Motion Detection in Section 9.1.1 for detailed steps.
5. Click Linkage Method to select the linkage methods for scene change,
including Notify Surveillance Center, Send Email, Upload to FTP/Memory
Card/NAS, Trigger Channel and Trigger Alarm Output.
6. Click Save to save the settings.
9.2.3 Configuring Dynamic Fire Source Detection
Purpose: