Quick Start Guide

[20]
3. Place the O-type gasket ② onto the end of the camera’s network
interface socket ①.
4. Insert the network plug ③ into the camera’s network interface
socket ①.
5. Insert the water-proof rubber gasket ⑤ into the waterproof
endcap ④, and secure lock nut ⑥ with the water-proof endcap
④.
6. Align the snap on the water-proof endcap ④ with the notch on
the camera’s network interface socket ①, and then secure the
water-proof endcap ④ to the camera’s network interface socket
① to finish installation.