User Manual

Thermal & Optical Bi-spectrum Network Bullet / Turret Camera User Manual
73
Figure 8-3 Day/Night Switch
Day: the camera stays at day mode.
Night: the camera stays at night mode.
Auto: the camera switches between the day mode and the night mode according
to the illumination automatically. The sensitivity ranges from 0 to 7, the higher
the value is, the easier the mode switches. The filtering time refers to the
interval time between the day/night switch. You can set it from 5s to 120s.
Scheduled-Switch: Set the start time and the end time to define the duration for
day/night mode.
Triggered by Alarm Input: The switch is triggered by alarm input. You can set the
triggered mode to day or night.
This function varies depending on the models of camera.
Smart Supplement Light: Set the supplement light as ON, and Auto and Manual
are selectable for light mode.
Select Auto, and the supplement light changes according to the actual luminance.
E.g., if the current scene is bright enough, then the supplement light adjusts
itself to lower power; and if the scene is not bright enough, the light adjusts
itself to higher power.
Select Manual, and you can adjust the supplement by adjusting the distance. E.g.,
if the object is near the camera, the device adjusts the supplement light to lower
power, and the light is in higher power if the object is far away.
This function varies depending on the models of camera.
 Backlight Settings