User Manual

Thermal & Optical Bi-spectrum Network Bullet / Turret Camera User Manual
104
 For leave/tree interference in the live view, shield settings is
recommended.
4. When the person exits, Click to stop auto calibration.
Figure 9-16 Auto Calibration
Verification:
i. Click the Enable Verification button.
Notes:
 Verify not only person, but also other objects appeared in the view.
Such as car, street lamp, etc.
 The verifying result value is only the height of the line. The horizontal
width is not measured.
ii. Click the Vertical Verify button, and drag a vertical line in the
view.
iii. Click the Calibration button to calculate the length.
iv. Compare the calculated line length to the actual length to verify the
calibration settings.
Note:
If the Auto Calibration failed, or the verified result turns bad, click Fig 1 to