User Manual

Thermal & Optical Bi-spectrum Network Bullet / Turret Camera User Manual
99
Figure 9-13 Fire Source Detection
3. Check the checkbox of Enable Dynamic Fire Source Detection to enable the fire
detection function.
4. Select detection mode from the dropdown list. Smoking Mode and Dynamic Fire
are selectable. Smoking mode is used to detect smoking behavior and the
dynamic fire detection mode is used to detect the fire source.
5. Check the checkbox of Display Fire Source Frame on Stream to display a red
frame around the fire source on stream when fire occurs. (Optional)
6. You can drag the slider to adjust the sensitivity degree of dynamic fire source
detection from 1 to 10. The bigger the number is, the more sensitive the
detecting would be.
7. Click Arming Schedule to set the arming schedule for the fire detection. Refer to
Task 2: Set the Arming Schedule for Motion Detection in Section 9.1.1.
8. Click Linkage Method and check the checkbox to select the linkage method taken
for the fire detection. Refer to Task 3: Set the Linkage Method for Motion
Detection in Section 9.1.1 for detailed steps.
9. Click Save to save the settings.
9.2.3 Configuring Fire Source Detection Shield
Purpose: