User Manual

Thermal & Optical Bi-spectrum Network Bullet / Turret Camera User Manual
95
9.1.4 Configuring Alarm Output
Figure 9-10 Alarm Output Settings
Steps:
1. Enter the Alarm Output Settings interface: Configuration> Event > Basic
Event > Alarm Output.
2. Select one alarm output channel in the Alarm Output drop-down list. You can
also set a name for the alarm output (optional).
3. The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or
Manual. The delay time refers to the time duration that the alarm output
remains in effect after alarm occurs.
4. Select the Alarm Type. The alarm type can be NO (Normally Open) and NC
(Normally Closed)
5. Click Arming Schedule to enter the Edit Schedule Time interface. The time
schedule configuration is the same as the settings of the arming schedule for
motion detection Refer to Task 2: Set the Arming Schedule for Motion Detection