User Manual

User Manual of Network Positioning System
© Hikvision
iv
Safety Instruction
These instructions are intended to ensure that the user can use the product correctly to avoid
danger or property loss.
The precaution measure is divided into ‘Warnings’ and ‘Cautions’:
Warnings: Serious injury or death may be caused if any of these warnings are neglected.
Cautions: Injury or equipment damage may be caused if any of these cautions are neglected.
Warnings Follow these safeguards to prevent
serious injury or death.
Cautions Follow these precautions to prevent
potential injury or material damage.
Warnings:
 Adopt the power adapter which can meet the safety extra low voltage (SELV) standard. The
power consumption cannot be less than the required value.
 Do not connect several devices to one power adapter as an adapter overload may cause
over-heating and can be a fire hazard.
 When the product is installed on a wall or ceiling, the device should be firmly fixed.
 To reduce the risk of fire or electrical shock, do not expose the indoor used product to rain or
moisture.
 This installation should be made by a qualified service person and should conform to all the
local codes.
 Install blackouts equipment into the power supply circuit for convenient supply interruption.
 If the product does not work properly, contact your dealer or the nearest service center.
Never attempt to disassemble the product yourself. (We shall not assume any responsibility
for problems caused by unauthorized repair or maintenance.)
Cautions:
 If the network positioning system fails to synchronize local time with that of the network, you
need to set up network positioning system time manually. Visit the network positioning
system (via web browser or client software) and enter system settings interface for time
settings.
 Make sure the power supply voltage is correct before using the product.
 Do not drop the product or subject it to physical shock. Do not install the product on
vibratory surface or places.